![]() For example, if you chose Select as your Hotkey, that means you hold down Select while pressing the other button to execute the command. The following chart shows the default hotkey combinations. It is suggested to use the Select button as the hotkey. The Hotkey button enables you to press it in combination with another button to access functions such as saving, loading, and exiting in emulators. Go ahead and configure your controller as per the diagram below: When you get to OK press the button you have configured as "A". Hold down any button on your keyboard or gamepad and the name will appear at the bottom and then open up into a configuration menu.įollow the onscreen instructions to configure your gamepad, if you run out of buttons just hold down a button to skip each unused button. The setup script will guide you through pairing the buttons. HOLD A BUTTON ON YOUR DEVICE TO CONFIGURE IT. To unbind (effectively, disable) a hotkey, press Del on your keyboard or the Y button (the left one of the 4 buttons) on the RetroPad. After a minute or so, EmulationStation will launch and ask you to configure your controller, you will see a screen that says: “WELCOME. Switch on the power to your Raspberry Pi. CTRL+ALT+T: This is the shortcut key to open the terminal of the Raspberry Pi operating system in order to manage different tasks through commands. If you have a basic controller, without all keys, press one key for a few seconds until the wizard moves to the next one. Then follow the wizard to configure all the controller keys. Press one key for a few seconds until RetroPie detects it. If you'd like to read more about navigating Batocera's frontend menus, refer to the dedicated EmulationStation overview page.How to Configure Your RetroPie Controller by Alan Pfahler on AugT19:13:36+00:00 When RetroPie asks you to plug your controller, do it. Batocera has attempted to make the shortcuts as consistent as possible across all emulators, but not all emulators support all functions, and some will behave differently with the same hotkey combination.Īlso, if you want to save/load your in-game progress through these hotkey combinations while you use RetroAchievements, make sure you haven't set your RetroAchievements settings to HARDCORE mode, as the hardcore mode prevents from using these save/load functionalities. This doesn't work with 100% of the emulators - mostly works well with Libretro emulators, but it can also depend on your architecture and options. Rewind (if enabled)/fast-forward (if available) ![]() Select shader/something specific to that emulator Take an in-emulator screenshot/something specific to that emulatorĪuto-translate/something specific to that emulator Send the reset command to the emulated system (if available) Write themes for batocera-emulationstation. ![]()
0 Comments
Leave a Reply. |